2" x 1 1/2" Mounted Pump; 0-170 PSI; 4200 RPM; 180 GPM; FMC-CW-200-X

MAXIMUM PRESSURE: 120 PSI (8.3 BAR)
MAXIMUM FLOW: 200 GPM (757 LPM)
MAXIMUM POWER: 7.5 HP (5.6 KW)

• Clockwise Rotation when facing shaft end

• Stainless Steel Shaft and Wear Ring

• Chemical resistant Valox^® or optional cast iron impeller

• Standard Viton^® Carbon/Ceramic seal or optional Severe Duty Silicon Carbide Mechanical seal

• MAG-D models equipped with heavy 12V clutch

• 3/4" (1.91cm) Diameter stainless steel shaft (standard models 5/8" diameter) (1.59 cm)
• Larger bearings for extended life
• Available with MAG-D clutch
• 5-1/4" (13.34 cm) mounting bolt spacing
• X3 frame has 3" (7.62 cm) bolt spacing

• Frame Mount Advantages

  Ace belt driven pumps are available in a variety of models which can be belt driven or direct coupled to a power source. The pumps are available in either clockwise or counterclockwise rotation. The standard bare shaft pumps are designed with a keyway for mounting a drive pulley or coupling.

• Magnetic Clutch Driven Advantages

  The integral magnetic clutch driven centrifugal pump design was first offered by Ace in 1982. These models enabled the operator to free the PTO shaft and hydraulic system for other uses. The 12 volt DC magnetic clutch is driven by a v-belt from the engine drive shaft. The clutch is idle until engaged by an on-off toggle switch located at the driver’s seat.

• Typical Clutch Installation

  Ace magnetic clutch driven frame mounted centrifugal pump models are available with counterclockwise (CCW) rotation and clockwise (CW) rotation. The direction of rotation is determined when facing the shaft. Sizes available are 1-1/4" x 1", 1-1/2" x 1-1/4", and 2" x 1-1/2".